Quilting How To

Quilting How To. This series is very deliberately written for any level of quilting experience, with one singular goal: Measure the height from the center of the screw hole to the needle plate:

Patchwork Table Runners from forum.xcitefun.net

In my view there are essentially four stages to making a quilt: Iron onto the background fabric. Jenny doan demonstrates the magic of tube sewing.

Source: www.pinterest.com

Ditch quilt the first seam to the right side of the center stitched line. When you come to a corner, sew in a straight line until you are about ¼ away from the end.

Source: www.freebirdquiltingdesigns.com.au

Finish the quilting by stitching on the spot. Jenny doan demonstrates the magic of tube sewing.

Source: www.pinterest.com

This hides the knot inside the batting. Insert the needle ½” away from where you plan to begin your actual stitches and without taking it through to the back bring the needle back up where you plan to start the stitches.

Source: www.etsy.com

When you come to a corner, sew in a straight line until you are about ¼ away from the end. Stitch from the top to the bottom inside the borders.

Source: www.etsy.com

Before you iron your applique piece down, doubly make sure it is placed on your background fabric straight and exactly where you want it. Lower the presser foot lever to down position.

Source: www.pinterest.com

In my view there are essentially four stages to making a quilt: Pivot the quilt so that you finish stitching at a 45 degree angle to your seam.

Source: www.pinterest.com

Measuring the shank on your machine. Once the anchor quilting is complete, return to the the first line of quilting.

It's fun, fast, easy, and makes various lovely quilting blocks.

Measure the height from the center of the screw hole to the needle plate: Stitch from the top to the bottom inside the borders. This hides the knot inside the batting.

Insert the needle ½” away from where you plan to begin your actual stitches and without taking it through to the back bring the needle back up where you plan to start the stitches.

After trimming the quilt, sew all four sides near the edges. Tips to help you set up a fabric cutting table. That’s why you need to ensure you square up and cut the binding perfectly straight for easy binding.

Before you iron your applique piece down, doubly make sure it is placed on your background fabric straight and exactly where you want it.

I always lay out my pieces and pin them down to make sure everything looks right and stays in place when i bring it over to my ironing board. Once the anchor quilting is complete, return to the the first line of quilting. Remove the quilt from the machine and fold over the binding.

About 1 inch for a high shank machine.

Continue pinning every six inches or so until you reach the corner. Finish the quilting by stitching on the spot. This series is very deliberately written for any level of quilting experience, with one singular goal:

Starting on one of the long sides of the quilt around the middle, pin the raw edge of the bias tape to the edge of the quilt, leaving a 6 inch tail of bias tape.

This video was inspired by an idea shared. Read our top tips for machine quilting for more advice about making your quilt by machine. About ½ inches for a low shank machine.